LevelOne GSW-4876 - Manual (Page 213)

C HAPTER 4 | Configuring the Switch
Configuring sFlow
– 213 –
Port Configuration
◆ Port – Port identifier.
◆ Flow Sampler – The following parameters apply to flow sampling:
■
Enabled – Enables/disables flow sampling on this port.
■
Sampling Rate – The number of packets out of which one sample
will be taken. (Range: 1-4096 packets, or 0 to disable sampling;
Default: Disabled)
■
Max. Header – Maximum size of the sFlow datagram header.
(Range: 14-200 bytes; Default: 128 bytes)
If the maximum datagram size does not take into account the
maximum header size, samples may be dropped.
◆ Counter Poller – The following parameters apply to the counter:
■
Enabled – Enables/disables counter polling on this port.
■
Interval – The interval at which the counters are updated.
(Range: 0-3600 seconds, where 0 disables this feature;
Default: Disabled)
W EB I NTERFACE
To configure flow sampling:
1.
Click Advanced Configuration, sFlow.
2.
Set the parameters for flow receiver, flow sampler, and counter poller.
3.
Click Save.