LiftMaster CSW24V High-Cycle Commercial DC Swing Gate Operator - Manual (Page 27)

25
DUAL GATES ONLY CONTINUED...
2
1
3
4
Before digging, contact local underground utility locating companies. Use PVC conduit to prevent damage to cables.
Disconnect ALL power to the operator and unplug the J15 plug from
the control board.
1
Trench across driveway to bury the extension cable.
2
Connect the wires from the extension cable to the Comm Link terminals on
the primary gate operator control board. NOTE: We recommend that all
accessories and board configurations are set on the primary operator.
3
Route the extension cable to the secondary gate operator's control board.
4
Connect the wires from the extension cable to the Comm Link terminals on
the secondary control board (Comm Link A to Comm Link A and Comm
Link B to Comm Link B).
Connect ALL power to the operator and plug the J15 plug into the
control board.
Comm Link Data A
Comm Link Data B
Comm Link Data A
Comm Link Data B
WIRED DUAL GATES
DUAL GATE WIRE TYPE (SHIELDED TWISTED PAIR CABLE)
22AWG up to 200 feet (61 m) 18AWG - 200-1000 feet
(61-305 m)
Wire must be rated at 30 Volt minimum
DUAL GATES ONLY
WIRING
BIPART DELAY/SYNCHRONIZED CLOSE
The LOCK/BIPART DELAY switch is used only with dual gate applications and
serves two functions:
• BIPART DELAY
SWING GATE APPLICATIONS: The BIPART DELAY is used in applications
where a mag-lock, solenoid lock, or decorative overlay would require one
gate to close before the other. The operator with the LOCK/BIPART DELAY
switch ON will delay from the close limit when opening and be the first to
close from the open limit.
SLIDE GATE APPLICATIONS: Not applicable, set to OFF.
• SYNCHRONIZED CLOSE
The BIPART DELAY is also used in applications where one gate travels a
longer distance than the other. To synchronize the closing of the gates, set
the LOCK/BIPART DELAY switch to ON for both operators.