Teledyne LeCroy WaveMaster 8 Zi_Zi-A - Manual (Page 108)

WaveMaster 8 Zi/Zi-A Oscilloscopes
100 922133-00 Rev A
PLEASE NOTE THE FOLLOWING:
The number of sweeps comprising the histogram is shown on the trace
descriptor label:
The range of a histogram is limited to the portion of the trace that is visible
on screen. That is, if you zoom in on a trace, the histogram does not
contain data for that part of the original (no longer visible) trace.
Single Parameter Histogram Setup
Setup a single parameter histogram can be done from Measure or Math
dialogs. The following sections demonstrate both methods.
S
INGLE
P
ARAMETER
H
ISTOGRAM
S
ETUP
U
SING
M
EASURE
Touch Measure → Measure Setup... on the menu bar to access the
Measure dialog. The My Measure button should be selected by default on
the Measure dialog.
There are two ways to select parameters when setting up your
measurement. They only differ in the order of the steps.

Using the Px Buttons on the Measure Dialog - After directly
touching a Px button on the Measure dialog, the Select
Measurement pop-up is shown.