Teledyne LeCroy WaveMaster 8 Zi_Zi-A - Manual (Page 70)

WaveMaster 8 Zi/Zi-A Oscilloscopes
62 922133-00 Rev A

SMART Triggers - sophisticated triggers that enable you to use basic
or complex conditions for triggering. Use SMART Triggers for signals
with rare features, like glitches.

Measurement Trigger - triggers that allow you to leverage
parameter measurements as waveform trigger conditions. A
measurement trigger is either the only trigger or the final trigger in a
chain of trigger events including hardware triggers.

MultiStage Triggers - varied forms of triggers including Cascaded,
QualFirst, and Qualified allowing varied combinations of triggers
and trigger stages.

Serial Triggers - provide serial data protocol specific triggering for a
wide variety of standards.
Trigger Types
There are a set of standard Trigger Types. These Triggers are basic
waveform features or conditions such as a positive or negative slope, and
hold-off and are available on all oscilloscopes along with tools like Software
Assisted Trigger and Trigger Scan.
In addition, there are more sophisticated triggers for setting basic or
complex conditions. These include Smart Triggers, Serial Trigger,
Measurement Triggers, and MultiStage Triggers.
To learn more, Contact Teledyne LeCroy for Support.
Edge
A simple trigger, Edge trigger is activated by basic waveform features or
conditions such as positive or negative slope, and holdoff.
Note: On WaveMaster 8 Zi and Zi-A, up to 15 GHz bandwidth is available
while Edge Triggering (provided no holdoff is selected).
Width