Teledyne LeCroy WaveMaster 8 Zi_Zi-A - Manual (Page 13)

Getting Started Manual
922133-00 Rev A 5
Power Consumption
≤ 975 watts (975 VA) for 4 - 16 GHz 8 Zi series models and 4 - 20 GHz
8 Zi-A series models.
≤ 1025 watts (1025 VA) for 20 - 30 GHz 8 Zi series models and
25 - 45 GHz 8 Zi-A series models (depending on accessories installed).
Power consumption in Standby Mode: 22 Watts.
Power and Ground Connections
The instrument is provided with a 15A/250V 14AWG rated grounded cord
set containing a molded three-terminal polarized plug and a specific IEC-
60320 (Type C15) connector for making line voltage and safety ground
connections.
The AC inlet ground is connected directly to the frame of the instrument.
For adequate protection again electric shock, connect to a mating outlet
with a safety ground contact.
WARNING. Interrupting the protective conductor inside or outside
the oscilloscope, or disconnecting the safety ground terminal,
creates a hazardous situation. Intentional interruption is prohibited.
Standby Power
The Standby (Power) button controls the operational state of the
oscilloscope. Press the button to switch the instrument into Standby mode
(reduced power); press it again to return to full operation.
Always use the Standby button or the File > Shutdown menu option to
execute a proper shut down process and preserve settings before powering
down.
The Standby button does not disconnect the oscilloscope from the AC
power supply. The only way to fully power down the instrument is to turn
the rear Power switch to the Off position, then unplug the AC power cord
from the outlet.
We recommend unplugging the instrument if it will be unused for a long
period of time.