Teledyne LeCroy WaveMaster 8 Zi_Zi-A - Manual (Page 141)

Getting Started Manual
922133-00 Rev A 133

Word - Available when selecting the Binary format, specifies
the samples in the output file are represented with 16 bits.
Always use this option unless Byte mode is pre.

Byte - Available when selecting Binary format, specifies the
samples in the output file are represented with 8 bits.
Note: This option can result in a loss of output file resolution.

Amplitude only - Specifies the output file include amplitude
data for each sample, but not sample time information.

Time and Amplitude - Specifies the output file include both
time and amplitude data for each sample.

With Header – Available with the Vector Signal Analysis
option, this includes a header with scaling information. This
stores the waveform in VSA recall format for later use.
PLEASE NOTE THE FOLLOWING:

Select Audio to save your waveforms in .wav format.

The WaveML format, which enables XML output, is used
for persistence traces.
7. If you selecteded ASCII, touch the Delimiter control and select a
delimiter character from the pop-up menu. Choose from comma,
space, semicolon, or tab delimiters.
8. You can use the Auto Save feature to automatically save a waveform
to disk after each new trigger.
9. Enable Auto Save from the Save Waveform dialog by touching one
of the Auto Save buttons.
10. Select Wrap (old files overwritten) or Fill (no files overwritten).
CAUTION. Selecting Fill can quickly use up all the hard disk
space on your instrument.