Teledyne LeCroy WaveMaster 8 Zi_Zi-A - Manual (Page 163)

Getting Started Manual
922133-00 Rev A 155
Miscellaneous
Other Preference setting controls are shown on the Miscellaneous dialog as
follows:
Numbers on this image correspond with the following explanations.
1. You can add the Teledyne LeCroy Logo to hardcopies of your grid
display waveforms by marking the Print Teledyne LeCroy Logo
When Printing Grid Area Only checkbox on the Hardcopy section of
the dialog.
2. You can adjust the Dimming and Control Sensitivity of Zoom traces
as follows:

Choose a Dimming of On, Off, and Auto values. This controls
the darkening/shading of waveform areas not part of the
Zoom trace.

Choose a Control Sensitivity of Legacy or Optimized values
3. If you have Serial Data Debug Solutions installed on your
oscilloscope, you can control Annotations being put On Trace (on all
traces) or On Noisy Trace (only on noisy traces).
4. You can shut off the SuperKnob Help flyout menu by un-marking the
SuperKnob Help checkbox on the Other section of the dialog.