Teledyne LeCroy WaveMaster 8 Zi_Zi-A - Manual (Page 161)

Getting Started Manual
922133-00 Rev A 153
E-Mail
Configure this dialog to send email from the oscilloscope.
1. On the E-Mail Server section of the dialog, choose a server protocol
from the following options:

MAPI (Messaging Application Programming Interface) is the
Microsoft interface specification that allows different
messaging and workgroup applications (including e-mail,
voice mail, and fax) to work through a single client, such as
the Exchange client. MAPI uses the default Windows e-mail
application.

SMTP (Simple Mail Transfer Protocol) is a TCP/IP protocol for
sending messages from one computer to another through a
network. This protocol is used on the Internet to route e-mail.
In many cases no account is needed.
2. Provide values for SMTP Server, Originator Address (From:), and
Default Recipient Address (To:) on the Configuration section of the
dialog based the MAPI or SMTP choice during the previous step.

If you chose MAPI, touch inside the Originator Address
(From:) data entry field and provide the instrument's e-mail
address. Then touch inside the Default Recipient Address
(To:) data entry field and provide the recipient's e-mail
address.

If you chose SMTP, touch inside the SMTP Server data entry
field and provide the name of your server. Touch inside the
Originator Address (From:) data entry field and provide the
instrument's e-mail address. Then touch inside the Default
Recipient Address (To:) data entry field and provide the
recipient's e-mail address.
3. The Overview of E-Mail modes section of the dialog provides helpful
descriptions for your Server selection.
4. Use the Send Test Mail button to ensure proper E-Mail configuration
by way of sending a confirmation message.