Teledyne LeCroy WaveMaster 8 Zi_Zi-A - Manual (Page 145)

Getting Started Manual
922133-00 Rev A 137
PLEASE NOTE THE FOLLOWING:

Use a stylus for this procedure. Using your finger for the
calibration prompts provides insufficient accuracy for the
procedure.

The calibration procedure times out after ten seconds pass
and no cross is touched.

Avoid parallax errors by placing your line of sight directly in
front of each cross before touching it.

The Service button is a section of the application reserved for
qualified Teledyne LeCroy personnel. When touched, an access code
pop-up is shown enabling Teledyne LeCroy technicians access to
various service dialogs inside the oscilloscope software.
To learn more, Contact Teledyne LeCroy for Support.
Status
Control values are shown for information about your instrument. Among
them include your Hardware and Software options.
View the oscilloscope's system status (including software and hardware
configurations) on this Status dialog. The dialog displays read-only system
information including model number, serial number, firmware version,
and installed software and hardware options.
New software options can be added after purchasing a code and then
enabling the option on the oscilloscope. Call Teledyne LeCroy Customer
Support to place an order and receive the code.

After adding new software options, the entire oscilloscope
application needs to be restarted. Do this by touching the desktop
shortcut.

Restart the Windows® operating system on your instrument (if
necessary) by rebooting the oscilloscope. Do this by pressing the
power switch, and then turning the power back on after a ten-
second wait.
Upon initial power-up, the oscilloscope automatically loads the instrument
application software along with any additional software options.