Teledyne LeCroy WaveMaster 8 Zi_Zi-A - Manual (Page 48)

WaveMaster 8 Zi/Zi-A Oscilloscopes
40 922133-00 Rev A
Whenever you turn on a channel, math, or memory trace using either the
menu bar or trace descriptor label, the dialog at the bottom of the screen
automatically switches to the vertical setup or math setup dialog for that
selection.
You can configure your traces from here, including math setups.
The Trace Dialog is shown on the lower portion of
the screen. The tab is labeled with the
corresponding channel number as follows:
Timebase
Overview
You can access Timebase settings using the front panel Horizontal controls,
the Timebase → Horizontal Setup... on the menu bar, or by touching the
Timebase trace descriptor label. The main Timebase dialog is then shown
and contains sections for Sampling Mode, Timebase Mode, and Real Time
Memory.
A section specifically used for combining channels is located on the far right
of the main Timebase dialog. This section varies based on your oscilloscope
model.
Timebase Setup and Control
1. With the Timebase dialog showing, touch inside the Time/Division
data entry control and provide a value.
2. Touch inside the Delay data entry control and provide a value.