Teledyne LeCroy USB Protocol Suite User Manual (Voyager_Advisor T3_Mercury) - Manual (Page 289)

USB Protocol Suite User Manual 289
Recording Rules ‐ USB 2.0 Teledyne LeCroy Corporation
10.7.5 Assigning an Action
After you have dropped the Event button in a cell in the Main Display area, you can assign
an action to the event.
Note:
If you do not assign an action to an Event button, the analyzer ignores the event.
To assign an action to an Event button:
1. Right‐click the Event button to display a pop‐up menu (see Figure 10.21 on
page 289 .)
Figure 10.21: Assigning Action to Event Button
2. Select Specify Action, and then choose an action from the submenu. The menu
closes, and the action is assigned.
Figure 10.22: Action Assigned
Note: You can also set actions within the Properties dialog for each event. Double‐click the Event
button to open the Properties dialog, then select the Actions tab and set your actions.