Teledyne LeCroy USB Protocol Suite User Manual (Voyager_Advisor T3_Mercury) - Manual (Page 95)

USB Protocol Suite User Manual 95
Status Bar Teledyne LeCroy Corporation
The status bar displays Triggered when the trigger condition has occurred, but uploading
has not commenced yet.
Figure 4.12: Status Bar - Triggered
The traffic data copies to disk (overwriting any previous version of this file) using the
default file name data.usb. You can also create a file name by specifying one in the
Recording Options dialog box.
To abort the upload process:
 Press Esc on the keyboard
OR
 Again click in the Tool Bar.
You are asked if you want to keep or discard the partially uploaded data.
Note: While uploading is in progress, clicking the Stop button again opens a dialog that allows you to
do a partial upload, flush the current file, keep what has uploaded at this point, or to continue
uploading.
The Partial Upload button enables when you have partially uploaded data. When you click
Partial Upload, a dialog box displays options on what portion of data you want to upload
again (see the following figure).
Figure 4.13: Partial Upload Options Dialog
When the data is saved, the Recorded Data file appears in the main display window, and
the Recording Status window clears.
 If the recording resulted from a Trigger Event, the first packet following the trig‐
ger (or the packet that caused the trigger) is initially positioned second from the
top of the display.
 If the recording did not result from a Trigger Event, the display begins with the
first packet in the traffic file.