Teledyne LeCroy USB Protocol Suite User Manual (Voyager_Advisor T3_Mercury) - Manual (Page 304)

Teledyne LeCroy Corporation Recording Rules ‐ USB 3.0 (Voyager/Advisor T3 only)
304 USB Protocol Suite User Manual
10.8.8 Events and Event Properties for USB 3.0
Recording rules are associations between events and actions. These associations
determine how trace recording occurs. The supported events for USB 3.0 are:
 Packet Type
 Link Management Packets
 Transaction Packets
 Data Packet Header
 Isoch Timestamp Packets
 Data Packet (DP) (for software version 3.71 and higher)
 Data Packet (DPH+DPP) (for software version 3.70 and lower) (see Data Pattern
note below)
 All Link Commands
 Link Command Flow Control
 LGOOD_0 through LGOOD_7 and LGOOD_n
 LBAD
 LCRD_A through LCRD_D and LCRD_x
 LRTY
 Link Command Link State
 LGO_U1, LGO_U2, LGO_U3
 LAU
 LXU
 LMPA
 LUP
 LDN
 LFPS
 Polling
 Ping
 Warm Reset (see Warm Reset Note below)
 U1 Exit
 U2/Loopback Exit
 U3 Wakeup
 All
 Training Sequences
 TS1
 TS2
 TSEQ
 Header Pattern
 Link Management Packet
 Set Link Function
 U2 Inact Tmt
 Vndr Dev Test
 Port Capability
 Port Config
 Port Cfg Rsp
 Transaction Packet
 ACK