Teledyne LeCroy USB Protocol Suite User Manual (Voyager_Advisor T3_Mercury) - Manual (Page 69)

USB Protocol Suite User Manual 69
Your First USB Recording Teledyne LeCroy Corporation
Figure 3.10: Recording Options - Voyager Dialog
Note:
Items not supported on your hardware are grayed out or not shown.
4. Click OK to activate the recording options you selected.
5. Turn on the USB devices that are to be tested and cause them to generate USB
traffic.
6. Click on the Tool Bar.
7. The system starts to record the USB traffic immediately. After 4 MB of traffic are
recorded, the Analyzer uploads the data and displays the packets in the trace
window.
8. To terminate recording before the snapshot automatically completes,

click on the Tool Bar.
9. When the recording session finishes, the traffic uploads from the Analyzer to the
hard drive on your host machine as a file named data.usb or the name you assigned
as the default filename. While the file is uploading, you should see a brown progress
bar at the bottom of the screen. When the bar disappears, the data has uploaded to
disk.