Teledyne LeCroy USB Protocol Suite User Manual (Voyager_Advisor T3_Mercury) - Manual (Page 58)

Teledyne LeCroy Corporation Cascading with CATC SYNC Expansion Card
58 USB Protocol Suite User Manual
3.4.2 Removing Expansion Cards
You can remove expansion cards using two tools:
 Standard (flat blade) 3/16” screwdriver
 Teledyne LeCroy Extraction Tool (part number 230‐0160‐00)
To remove an expansion card, follow these steps:
1. Unplug the system from AC power and turn the system so the expansion port is
facing you. Note the two retaining screws and the holes for the extraction tool that
are located on the panel of the expansion card.
Note: The example shows a different expansion card, but the removal method is the same.
2. Insert the extraction‐tool prongs into the holes in the expansion card panel.
Note: If the prongs do not slip easily into the holes, use a small nail file or similar device to remove
paint from the prongs.