Teledyne LeCroy USB Protocol Suite User Manual (Voyager_Advisor T3_Mercury) - Manual (Page 63)

USB Protocol Suite User Manual 63
Application Startup Teledyne LeCroy Corporation
3.5.3 IP Settings (Voyager only)
If connected to a device, you can change the IP settings:
 DHCP automatically assigns an IP address. DHCP is the default.
 Static IP prompts you to enter a specific IP address.
To change from DHCP to Static IP while connected to a device:
1. Select Setup > All Connected Devices from the menu bar to display the
Analyzer Devices dialog.
Figure 3.2: Analyzer Devices Dialog
Note:
If you are not connected to a device, the IP Settings command is grayed out.
2. Select the device to use in the recording, then click the IP Settings button to display
the Device IP Settings dialog.
Figure 3.3: Device IP Settings Dialog
Two radio buttons are available:
 Obtain IP address automatically (DHCP) [default]
 Use the following IP Address (Static IP)