IEI Integration RPC-6010G - Manual (Page 30)

RPC-6010G Rackmount LCD Workstation
Step 3:
Step 4:
Step 5:
Step 6:
Step 7:
Use box cutters, a knife or a sharp pair of scissors to open the top of the internal
(first) box.
Lift the workstation out of the boxes.
Remove both polystyrene ends from each side.
Pull the plastic cover off the workstation.
Make sure all the components listed in the packing list are present.
Step 0:
4.2.3 Packing List
NOTE:
If some of the components listed in the checklist below are missing, please do
not proceed with the installation. Contact the IEI reseller or vendor you
purchased the AC-KIT-883HD audio module from or contact an IEI sales
representative directly. To contact an IEI sales representative, please send an
email to [email protected] .
When the RPC-6010G rackmount workstation is received, make sure all the components
listed below are present.
Quantity Description Image
1 Backplane to SBC connector cable
2 Door key
2 Handle
Page 20