5” disk drive in a 5.25” slot, 2 3.5” disk drive in a 5.25” slot, Figure 4-8: 5.25” disk drive retention screws – IEI Integration RPC-6010G User Manual
Page 40
RPC-6010G Rackmount LCD Workstation
Step 5:
Insert the appropriate number of retention screws into each side of the 5.25”
disk drive through the drive bracket (Figure 4-8).
Step 0:
Figure 4-8: 5.25” Disk Drive Retention Screws (Other Side Similar)
4.5.6.2 3.5” Disk Drive in a 5.25” Slot
With the use of IEI’s 3.5” to 5.25” drive bay rack, a standard 3.5” disk drive can be installed
into a 5.25” drive bay slot. To install a 3.5” hard disk drive into a 5.25” slot of the drive
bracket, follow the instructions below.
Step 1:
Step 2:
Slide a 3.5” disk drive into a 3.5” to 5.25” drive bay rack. Make sure the
IDE/SATA connector and the power connectors of the drive are facing the rear of
the rack.
Insert the appropriate number of retention screws into each side of the 3.5” disk
drive through the 3.5” to 5.25” drive bay rack (Figure 4-9).
Page 30