IEI Integration RPC-6010G - Manual (Page 38)

RPC-6010G Rackmount LCD Workstation
Step 3:
Step 1:
Remove the CPU card clamp and drive bay bracket from the chassis. Step 0:
4.5.4 Remove the Drive Bracket
The drive bracket is secured to the RPC-6010G rackmount workstation with four retention
screws. To remove the drive bracket, please follow the steps below.
Remove four retention screws that secure the drive bracket to the chassis
(Figure 4-4).
Figure 4-6: Drive Bracket Retention Screws
Step 2:
Step 1:
Remove the drive bracket from the chassis. Step 0:
4.5.5 Remove the Drive Slot Blank Plate
The drive bracket has three 5.25” and one 3.5” drive slot blank plates. To remove the drive
slot blank plates, please follow the steps below.
Remove the retention screws from each side of the drive bracket that secure the
drive slot blank plates to the drive bracket (Figure 4-5).
Page 28