IEI Integration RPC-6010G - Manual (Page 36)

RPC-6010G Rackmount LCD Workstation
4.5.2 Remove the CPU Card Clamp
The CPU card clamp is secured to the RPC-6010G rackmount workstation with four
retention screws. To remove the CPU card clamp, please follow the steps below.
Step 1: Remove four retention screws, two each on the left and right sides of the
workstation, that secure the CPU card clamp to the chassis (Figure 4-3).
Figure 4-3: CPU Card Clamp Right Side Retention Screws (Left Side Similar)
Step 2:
Step 1:
Remove the CPU card clamp from the chassis. Step 0:
4.5.3 Remove the Dual CPU Card Clamp & Drive Bay Stabilizer Bracket
The dual CPU card clamp and drive bay stabilizer bracket is secured to the RPC-6010G
rackmount workstation with 10 retention screws. To remove the dual CPU card clamp and
drive bay stabilizer bracket, please follow the steps below.
Remove the six retention screws that secure the dual CPU card clamp and drive
bay stabilizer bracket to the sides of the workstation chassis (Figure 4-4).
Page 26