IEI Integration RPC-6010G - Manual (Page 59)

RPC-6010G Rackmount LCD Workstation
Step 3:
Step 4:
Step 5:
Step 6:
Step 7:
Step 8:
Step 9:
Step 10:
Step 11:
Step 12:
Step 13:
Step 1:
Step 2:
Step 3:
Step 4:
Open the top cover of the RPC-6010G rackmount workstation.
(See Section 4.5.1)
Disconnect all internal and external peripheral device connections
from the CPU card.
Remove the CPU card clamp. (See Section 4.5.2)
Remove the dual CPU card clamp and drive bay stabilizer bracket. (See
Section 4.5.3)
Remove the retention screw that secures the CPU card to the slot on the rear
panel.
Slide the CPU card out of the workstation.
Install a new CPU card. (See Section 4.5.9)
Reinstall the CPU card clamp.
Reinstall the dual CPU card clamp and drive bay stabilizer bracket.
Reinstall the top cover of the workstation.
Reinstall the workstation into the rack. Refer to Section 4.6 for complete
mounting instructions. Step 0:
5.3 PCI/ISA Expansion Card Replacement
To replace a PCI/ISA expansion card, please follow the instructions below.
Turn off and disconnect the workstation from all power sources.
Remove the workstation from the rack in which it is installed.
Open the top cover of the RPC-6010G rackmount workstation.
(See Section 4.5.1)
Disconnect all internal and external peripheral device connections from the
PCI/ISA expansion card.
Page 49