IEI Integration RPC-6010G - Manual (Page 60)

RPC-6010G Rackmount LCD Workstation
Step 5:
Step 6:
Step 7:
Step 8:
Step 9:
Step 10:
Step 11:
Step 12:
Step 13:
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Remove the CPU card clamp. (See Section 4.5.2)
Remove the dual CPU card clamp and drive bay stabilizer bracket. (See
Section 4.5.3)
Remove the retention screw that secures the PCI/ISA expansion card to the slot
on the rear panel.
Slide the PCI/ISA expansion card out of the workstation.
Install a new PCI/ISA expansion card. (See Section 4.5.10)
Reinstall the CPU card clamp.
Reinstall the dual CPU card clamp and drive bay stabilizer bracket.
Reinstall the top cover of the workstation.
Reinstall the workstation into the rack. Refer to Section 4.6 for complete
mounting instructions. Step 0:
5.4 Backplane Replacement
To replace a backplane, please follow the instructions below.
Turn off and disconnect the workstation from all power sources.
Remove the workstation from the rack in which it is installed.
Open the top cover of the RPC-6010G rackmount workstation.
(See Section 4.5.1)
Remove the CPU card clamp. (See Section 4.5.2)
Remove the dual CPU card clamp and drive bay stabilizer bracket. (See
Section 4.5.3)
Disconnect and remove all CPU cards (see Section 4.5.9) and PCI/ISA
expansion cards (see Section 4.5.10).
Page 50