IEI Integration RPC-6010G - Manual (Page 61)

RPC-6010G Rackmount LCD Workstation
Step 7:
Step 8:
Step 9:
Step 10:
Step 11:
Step 12:
Step 13:
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Remove the retention screws that secure the backplane to the workstation
(see Section 4.5.8).
Install a new backplane into the chassis.
Reinstall and reconnect all CPU cards (see Section 4.5.9) and PCI/ISA
expansion cards (see Section 4.5.10).
Reinstall the CPU card clamp.
Reinstall the dual CPU card clamp and drive bay stabilizer bracket.
Reinstall the top cover of the workstation.
Reinstall the workstation into the rack. Refer to Section 4.6 for complete
mounting instructions. Step 0:
5.5 PSU Replacement
To replace a PSU, please follow the instructions below.
Turn off and disconnect the workstation from all power sources.
Remove the workstation from the rack in which it is installed.
Open the top cover of the RPC-6010G rackmount workstation.
(See Section 4.5.1)
Remove the CPU card clamp. (See Section 4.5.2)
Disconnect all the PSU cables from their devices.
Remove the four external retention screws that secure the PSU assembly to the
rear panel of the workstation (Figure 5-1).
Page 51