Install drives, 25” disk drive, 6 install drives – IEI Integration RPC-6010G User Manual
Page 39: 1 5.25” disk drive
RPC-6010G Rackmount LCD Workstation
Figure 4-7: Drive Slot Blank Plate Retention Screws (Other Side Similar)
Step 2:
Step 1:
Step 2:
Step 3:
Step 4:
Remove the drive slot blank plate from the drive bracket.
Step 0:
4.5.6 Install Drives
4.5.6.1 5.25” Disk Drive
The drive bracket supports three 5.25” disk drives. To install a 5.25” disk drive, follow the
instructions below.
Remove the dual CPU card clamp and drive bay stabilizer bracket from the
RPC-6010G rackmount workstation (see Section 4.5.3).
Remove the drive bracket from the RPC-6010G rackmount workstation (see
Section 4.5.4).
Remove the appropriate drive slot blank plate (see Section 4.5.5).
Slide the 5.25” disk drive into the drive bracket. Make sure the IDE/SATA
connector and the power connector of the drive are facing the rear of the
bracket.
Page 29