Lincoln Electric IM10114 TANDEM CRUISER - Manual (Page 16)

A-9 INSTALLATION
TANDEM CRUISER™
A-9
FRONT WHEELS
In almost all configurations the front wheels must
remain parallel with the Cruiser base and rear wheels.
Improper adjustment of the front wheels will cause
inconsistent tracking of the joint, accelerate wheel
wear, poor operation on K396 track and may lead to
travel motor overload errors.
Only adjust the front wheels when welding a round
inside or outside seam 25 feet (7.6m) in diameter or
smaller. At all other times the front wheels must be set
to 90°.
To steer the front wheel to the left, loosen bolt A and
tighten bolt B to set the angle, then snug bolt A.
To steer the front wheel to the right, loosen bolt B and
tighten bolt A to set the angle, then snug bolt B.
FIGURE A.10 FRONT WHEEL ADJUSTMENT
FIGURE A.11 ADJUSTMENT 25 FEET DIA. OR SMALLER
FIGURE A.12 DIRECTION OF TRAVEL