Lincoln Electric IM10114 TANDEM CRUISER - Manual (Page 44)

B-8 OPERATION B-8
MEMORIES
The TANDEM CRUISER™ has 4 memories. Each
memory stores :
• Weld Mode
• Amperage (or WFS)
• Voltage
• Travel Speed
• Frequency
• Balance
• DC Offset
• Arc Start Options
• Arc End Options
Recall a memory with memory buttons
To recall a memory, press one of the four memory but-
tons. The memory is recalled when the button is
released. Do not hold the button for more than two sec-
onds.
Save a memory with memory buttons
To save a memory, press and hold the desired memo-
ry button for two seconds. When the button is initially
pressed, the corresponding LED will illuminate. After
two seconds, the LED will turn off. Do not hold the but-
ton for more than 5 seconds when saving a user mem-
ory.
Note that memories may be locked in the set-up menu
to prevent accidental overwrite of the memories. If an
attempt is made to save a memory when memory sav-
ing is locked, the message "Memory save is Disabled!"
will appear briefly in the MSP4 display.
LIMITS
Limits allow the welder to adjust the welding procedure
only within a defined range.
Each memory may have a different set of limits. For
example, memory 1 may limit the WFS to 100 through
120 in/min, and memory 2 may limit the WFS to 140
through 160 in/min, while memory 3 may have no WFS
limits.
Parameters are constrained by machine limits, or by
setting memory limits. When memory limits are
enabled, the parameter will flash whenever an attempt
is made to exceed the memory limit value. The para-
meter will not flash if an attempt is made to exceed the
machine limit.
Limits may be set for:
Wire Feed Speed
Voltage
Amperage
Travel Speed
Frequency
Balance
DC Offset
Arc Start Options
Arc End Options
Weld modes cannot be selected through the Limits
Setup menu, and must be chosen and saved to mem-
ory before entering the Limits Setup Menu.
TANDEM CRUISER™
FIGURE B.17 - MEMORIES
FIGURE B.18 - LIMITS