Lincoln Electric IM10114 TANDEM CRUISER - Manual (Page 20)

A-13 INSTALLATION
TANDEM CRUISER™
A-13
WIRE REEL ENCLOSURE ASSEMBLY
1. Determine the angular orientation of the wire reel
enclosure relative to the spindle clamp. To change
the angle of the enclosure, remove the 6 bolts
securing the enclosure back to the mounting brack-
et using a 7/16” wrench. Reassemble at the desire
angle, keep the gasket centered relative to the
enclosure back. Provisions are made to rotate the
enclosure in 30° increments.
2. Unscrew the spindle brake and remove the spindle
brake parts and the spindle.
3. Remove two of the bolts from the spindle assem-
bly using a 1/4” hex key. Assemble the enclosure
back to the spindle assembly and tighten the bolts.
FIGURE A.16 - ENCLOSURE ASSEMBLY
FIGURE A.17 - ENCLOSURE MOUNTING
BRACKET
GASKET
ENCLOSURE
BACK
HARDWARE