Lincoln Electric IM10114 TANDEM CRUISER - Manual (Page 21)

A-14 INSTALLATION
TANDEM CRUISER™
A-14
4. Reassemble the spindle parts as shown.
5. If required, swap the position of the ball bushing
assembly. Use a 7/16” wrench to loosen and
tighten the hardware.
6. Thread the conduit into the brass fitting on the
ball bushing assembly. Then slide the boot along
the conduit and over the brass fitting.
7. When assembling the enclosure cover to the
enclosure back, verify the cover is evenly seated
all the way around.
FIGURE A.18 - SPINDLE PARTS
FIGURE A.19 - CONDUIT, BRASS FITTING, BOOT