Lincoln Electric IM10114 TANDEM CRUISER - Manual (Page 30)

A-23 INSTALLATION
TANDEM CRUISER™
A-23
To configure the TANDEM CRUISER™ for Flat
Fillet welding.
1. Turn off power at the power sources.
2. Remove the lift bail from the mast.
3. Disconnect the lead wire drive and laser cable, lead
electrode sense lead and trail wire drive cable.
4. Remove the lead wire drive and trail wire drive from
the mounting bracket.
5. Remove the slide assembly from the Cruiser mast.
Remove the collar from the mast.
6. Remove the boom and spindle assembly.
7. Loosen the 8 bolts as shown, then rotate the upper
structure 45°. Reassemble using the bolts that are
1.00” long. (See Figure A.32)
See Step 8
TILT MAST
TANDEM FLAT
FIGURE A.32 - FLAT FILLET 45° (TROUGH)