Wiegmann WAX-MSSN4 Series - Manual (Page 30)

W A X - U & W A C P X - U S E R I E S E N C L O S U R E S
N E M A 1 2 F L O O R - M O U N T D I S C O N N E C T
www.hubbell-wiegmann.com
Data Subject To Change Without Notice
"WACPX-U" Style Enclosure "WAX-U" Style Enclosure
K G + 1.18
F
E
OF PANEL L
C
C
L
TOP OF DISCONNECT
TOP HOLE IN
DISCONNECT HANDLE
WB
2.06 2.06
WB
PANEL
E
F
G 2.44
L
C
PANEL
THIS SPACE
OCCUPIED BY
DISCONNECT
SWITCH AND
FUSE CLIP
(IF USED) OR
CIRCUIT BREAKER
AND OPERATING
HANDLE
TOP OF DISCONNECT
TOP HOLE IN
DISCONNECT HANDLE
THIS SPACE
OCCUPIED BY
DISCONNECT
SWITCH AND
FUSE CLIP
(IF USED) OR
CIRCUIT BREAKER
Note:
1. See pages F51-F60 for various brands of disconnects for “E”, “F”, “G”, “K”
and “WB” dimensions.
2. Disconnects will occupy space on panel shown by dimensions “E”, “F”,
“G” and “K”. Wiring space “WB” is available when disconnect is installed
in the enclosure.
3. When ordering 24.13 (613mm) deep enclosures, long connecting
rods must be ordered. Long connecting rods are available from dis-
connect manufacturers.
• ABB Controls flange-operated devices
• Eaton Cutler-Hammer C361 devices
• Eaton Cutler-Hammer C371 operating mechanisms C371E and
C371F, order catalog number C371CS1 connecting rod. For C371G
and C371K, order catalog number C371CS2 connecting rod.
• General Electric TDA devices, order catalog number TDSR
extended length drive rod
• For Schneider Square D ® 9422 devices, order catalog number
9422-R2 extra long operating rod(s). Some devices require two
rods.
Refer to National Electrical Code ® article 430-10(b) for wiring space
required for line side conductors to be connected to disconnect. Verify your
application to determine if wiring space is adequate.
Space Occupied by Disconnect
F30