Wiegmann WAX-MSSN4 Series - Manual (Page 6)

N 4 1 2 - C D N 4 1 2 - C D S S U LT I M AT E S E R I E S E N C L O S U R E S
N E M A 4 1 2 F L A N G E D S I N G L E D O O R D I S C O N N E C T
( C A R B O N , 3 0 4 A N D 3 1 6 L S TA I N L E S S S T E E L )
F6
www.hubbell-wiegmann.com
Data Subject To Change Without Notice
F E AT U R E S - S P E C I F I C AT I O N S
Industry Standards
UL 508, Types 12, 13, 4 & 4X
CSA Certified, Type 12, 13, 4 & 4X
NEMA/EEMAC Types 12, 13, 4 & 4X
U L F i l e s E 6 4 7 9 1
C S A F i l e L L 6 6 0 7 8
Accessories
• Back panels (reference tables)
• Blank Adapter Plates on page F61
IMPORTANT Ordering Information
• See F2 for disconnect switch, circuit
breakers, operating handle and oper-
ating mechanism.
• Door latching system installed on
door with a slotted insert defeater
mechanism to open
• Latching system interlocks with the
disconnect handle for added safety
• 2pt latch system up to 36" in height
and 3pt latch system on enclosures
42" and higher
Finish
• ANSI 61 gray polyester powder
inside and out over phosphatized
surfaces
• Stainless steel enclosures #4 brush
finish
• Optional back panels are white
polyester powder over phospha-
tized surfaces
• Optional “G” panels have a con-
ductive finish
A
B
Construction
• CD enclosure version bodies and
doors fabricated from 14 gauge
carbon steel
• CDSS enclosure version bodies
and doors fabricated from 14
gauge 304 stainless steel 316L also
available)
• Continuously plasma welded seams
• Increased tub opening for better
access
• Concealed hinges
• Doors are interchangeable and
easily removable
• Grounding provisions provided
• Doors are sealed with poured-in-
place polyurethane gasket
• Mounting holes in rear of enclosure
• Studs for mounting optional sub
panel
*See Page F27 for Stiffener Location.