Wiegmann WAX-MSSN4 Series - Manual (Page 38)

W A X M - U S E R I E S E N C L O S U R E S
N E M A 1 2 H E AV Y D U T Y F R E E S TA N D I N G D I S C O N N E C T
F38
www.hubbell-wiegmann.com
Data Subject To Change Without Notice
PANEL
2.94 FOR 3, 4 & 5 DOOR
4.06
WB
E
F
G 2.44 FOR 1 & 2 DOOR
BREAKER
OR CIRCUIT
(IF USED)
FUSE CLIP
SWITCH AND
DISCONNECT
OCCUPIED BY
THIS SPACE
DISCONNECT HANDLE
TOP HOLE IN
TOP OF DISCONNECT
L
C
Space Occupied by Disconnect
Note:
1. See pages F51-F60 for various brands of disconnects for “E”, “F”, “G” and “WB” dimensions.
2. Disconnects will occupy space on panel shown by dimensions “E”, “F” and “G”. Wiring space “WB”
is available when disconnect is installed in the enclosure.
3. When ordering 24.13 (613mm) deep enclosures, long connecting rods must be ordered. Long
connecting rods are available from disconnect manufacturers.
• ABB Controls flange-operated devices
• Eaton Cutler-Hammer C361 devices
• Eaton Cutler-Hammer C371 operating mechanisms C371E and C371F, order catalog
number C371CS1 connecting rod. For C371G and C371K, order catalog number C371CS2
connecting rod.
• General Electric TDA devices, order catalog number TDSR extended length drive rod
• For Schneider Square D
® 9422 devices, order catalog number 9422-R2 extra long operating
rod(s). Some devices require two rods.
Refer to National Electrical Code ® article 430-10(b) for wiring space required for line side conductors
to be connected to disconnect. Verify your application to determine if wiring space is adequate.