Yokogawa Removable Chassis DX1000N - Manual (Page 91)

2-24 IM 04L41B01-01E
2.12 Using the USB Flash Memory (/USB1 Option)
Connecting/Removing a USB Flash Memory
• Connecting a USB Flash Memory
If you are using the multi batch function (/BT2 option), see the DX1000/DX1000N/
DX2000 Multi Batch (/BT2) User’s Manual, IM04L41B01-03E.
1. Connect a USB flash memory to the USB port on the DX.
2. In operation mode, possible operations are shown. Select the desired operation
using the arrow keys and press DISP/ENTER.
When set to auto save When set to manual save
Setting Description
Save Manual Saves unsaved data in the internal memory to a USB flash memory
device.
DATA SAVE MODE Switches to the DATA SAVE MODE display. For the procedure
to save the internal memory data, see section 4.8. This item only
appears when the DX is configured to display DATA SAVE MODE in
the display menu (release number 2 and later). You can change the
item that is displayed here with the menu customize function.
Load Settings Moves to the setup load display of setting mode. For the procedure
to load the setup data, see section 6.9.
Load Settings will not be displayed:
• When Media/USB loading is locked (see chapter 8 for details).
• When the DX is accessing storage media (formatting, saving, or
FTP communication).
Cancel Closes the operation selection window.
• Removing the USB Flash Memory
1. In the operation mode, press FUNC.
The FUNC key menu appears.
2. Press the Media eject soft key and then the USB soft key.
A message “Media can be removed safely.” appears.
3. Remove the USB flash memory.
Note
• One USB flash memory can be connected.
• Be sure to carry out the procedure above when removing the USB flash memory. If you
remove the USB memory without performing the above procedure, the data stored on it
could be damaged.