Yokogawa DAQWORX - Manual (Page 34)

2-10 IM WX13-01E
2.4 Entering Data Logging Conditions
Switching the Display ON/OFF, and Selecting/Clearing Items
When you click a check box, the box’s color switches from blue to Gray.
Blue: display ON, selected
Gray: display OFF, cleared
Clicking to Change Settings
For the setting items in the figure below, clicking the cell causes the setting item to
change.
You can change the alarm trigger under logging settings, the direction under level
trigger settings, the Y-axis under group settings, the alarm level under channel
settings, and others.
Using the Shortcut Buttons (Operation When Setting the Display
Conditions)
There are five types of shortcut buttons.
A B A A D A C E E D D A E A E E
Short cut buttons allow you to enter settings into each item of a range of selected
waveform numbers. If a range of waveform numbers is not selected, the action applies
to all waveform numbers.
A: Shows, hides, or sets the selected items in the column.
B: Channel numbers are filled from the first cell in the selection to the last, each
channel being assigned a number 1 higher than the last.
C: Switches the meter type of the selected range.
D: Copies the first value in the selected range to all items in the selected range.
E: Sets the selected values to their defaults.
Applying the Display Condition Settings to the Display Conditions of Data
Monitor
Select the Updates display settings to Data Monitor check box. The settings are
applied to Data Monitor when you click Apply or OK. However, Data Monitor must be
running in this case.
Saving the Settings
Click Apply to save the settings. In this case, the Configuration dialog box remains
open.
Click OK to save the settings and close the Configuration dialog box.
Click Cancel to cancel the settings and close the Configuration dialog box.