Yokogawa DAQWORX - Manual (Page 71)

4-11 IM WX13-01E
Monitoring Data (Data Monitor)
1
2
3
4
5
Index
6
2. Select the check boxes for the items to be copied and click OK. The dialog box
closes.
3. Click the tab corresponding to the copy source group.
4. Click Copy.
5. Click the tab corresponding to the copy destination group.
6. Click Paste.
Showing/Hiding the Waveform, Y-Axis, Trip 1, and Trip 2
• Click the waveform number, Y-axis, trip 1, and trip 2 check boxes to switch between
show (blue) and hide.
• If consecutive cells are selected, you can click the shortcut tool at the bottom of the
screen to switch the show/hide setting of all the cells in the selected range.
Using the Shortcut Buttons
There are five kinds of shortcut buttons.
You can enter a setting on every cell in a selected range all at once. If a range of
items is not selected, the action applies to all items.
A: Shows or hides the selected items in the column.
B: Channel numbers are filled from the first cell in the selection to the last, each
channel being assigned a number 1 higher than the last.
C: Switches the meter type of the selected range.
D: Copies the first value in the selected range to all items in the selected range.
E: Sets the selected values to their defaults.
Saving the Settings
Click Apply to save the settings. In this case, the General Display Settings dialog
box remains opened.
Click OK to save the settings and close the General Display Settings dialog box.
Click Cancel to cancel the settings and close the General Display Settings dialog
box.
Note
If Data Monitor is running, the display settings entered on the Launcher can automatically be
copied to the general display settings of Data Monitor (see “Basic Operation” in section 2.4).
4.2 Setting the Display Conditions