Yokogawa DAQWORX - Manual (Page 95)

5-12 IM WX13-01E
• Slide Zone
The zone width of each waveform is made equal, and the start position of the display
zone is offset slightly for each waveform.
• Auto Zone
Displays the waveforms by equally dividing the waveform display area according to
the number of displayed waveforms.
• Multi-Axis Zone
Displays the waveforms and multiple Y-axis (scale) in the zone specified in the
General Display Settings.
You can add/delete the Y-axis by carrying out the following procedure.
When adding a Y-axis: In the zone display area, drag the zone bar to be displayed
in the waveform display area.
When deleting a Y-axis: In the waveform display area, drag the Y-axis to be deleted
and drop it in the zone display area.
Drag & drop the zone bar corresponding to the
Y axis (scale) of the channel you wish to display
Drag & drop the Y axis (scale) to be deleted
Note
The waveform display area shows a grid that corresponds to the right-most Y-axis (scale). In
addition, only the trip lines of the channels that have the right-most Y-axis are displayed.
5.3 Changing the Waveform Display and Numerical Display