Yokogawa DAQWORX - Manual (Page 39)

2-15 IM WX13-01E
Entering Settings (Launcher)
2.4 Entering Data Logging Conditions
1
2
3
4
5
Index
6
4. Click a channel to scan.
The Channel No. dialog box opens.
5. Click the channel of the level you wish to scan. Here, if the channel settings
from the currently downloaded monitor server information applies to the selected
scanning channel, the channel is displayed in black. If it does not apply, or if it
does apply but scanning for that channel is turned OFF (see page 1-13, “Channel
Settings”), the channel is displayed in Gray.
6. Click a Level value box and enter the value for the reference level.
7. Click the Slope box and choose UP or DOWN.
UP: Starts logging when data from the scanned channel exceeds the level.
DOWN: Starts logging when data from the scanned channel falls below the level.
Paste
This button pastes the channel assignments copied when clicking the Copy button
under Group Setting Information (see page 2-19) into the Alarm Trigger Configuration
dialog box. If channels being simultaneously scanned are separated into groups,
this Paste function instantly copies channels assigned to certain groups to the Alarm
Trigger Configuration dialog box as scan channels.
Note
• If scan channels are not active and if scan is OFF (colored Gray), those channels’ conditions
are always considered to be unmet.
• If an overrange occurs on the scanned channel (+OVER or –OVER), the value for the
channel condition is considered to be positive infinity or negative infinity. In other words,
the level is always considered to have been exceeded on a +OVER, and not reached on a
–OVER regardless of the scanned channel’s specified level.