Yokogawa DAQWORX - Manual (Page 73)

4-13 IM WX13-01E
Monitoring Data (Data Monitor)
1
2
3
4
5
Index
6
2. Click the desired channel. The channel is selected and the dialog box closes.
To not assign a channel, click None at the bottom.
Showing/Hiding the Waveform
Select the No. check box.
Blue: Shows the waveform.
Gray: Hides the waveform.
Y-Axis
Set whether to show or hide the Y-Axis when multi-axis zone is selected. Click the check
box.
Blue: Shows the Y-axis.
Gray: Hides the Y-axis.
Specifies the axis type. Linear and Log toggle each time the box is clicked.
Linear: Linear scale.
Log: Logarithmic scale.
Display
Set the display format for numeric values. Select floating-point (100.0) or exponential
(1.000E2). Floating-point and exponential toggle each time the box is clicked.
Meter Type
Click one of the option buttons to select the type of meter to be displayed on the meter
monitor from bar meter, analog meter, and thermometer.
Scale
Click the value box and enter the maximum and minimum values of the scale.
The range of values that can be entered is from -999999999 to 999999999 excluding the
decimal point.
If you set the minimum value larger than the maximum value, the waveform is inverted.
Note
The decimal point position of the entered value is adjusted according to the number of
significant digits to the right of the decimal point.
Zone
Click the value box and enter the maximum and minimum values of the waveform display
zone. The range of values that can be entered is 0 to 99% for the minimum value and 1
to 100% for the maximum value.
Trip 1 and Trip 2
Click the value box and enter the position of the trip line within the scale range.
When you enter a value, the check box turns blue. If you do not wish to use the trip line,
clear the check box.
Blue: Enable.
Gray: Disabled.
Note
Trip line 1 and 2 are displayed in red and blue, respectively.
4.2 Setting the Display Conditions