Mammoth 800 to 5500 CFM: Dedicated Outdoor Air System with Enthalpy Wheels (VHC) - Manual (Page 34)

MAMM-VHC-IOM-1A (JANUARY 2013) 34
Table H3: Start-up Readings
Mode of Operation Heating Cooling
Compressor
refrigerant
side
Circuit #1
Discharge pressure – PSI
Suction pressure – PSI
Discharge temperature – °F
Suction temperature – °F
Superheat – °F
Subcooling – °F
Site glass oil level
__½ __¾
__F
Site glass clear __Yes __No
Amps – L1/L2/L3
Circuit #2
Discharge pressure – PSI
Suction pressure – PSI
Discharge temperature – °F
Suction temperature – °F
Superheat – °F
Subcooling – °F
Site glass oil level
__½ __¾
__F
Site glass clear __Yes __No
Amps – L1/L2/L3
Electric
heating
Stage 1 2 3 4 5 6
Amp draw – L1
Amp draw – L2
Amp drave – L3
This unit has been checked out and started according
with the above procedures and completed forms and is
operating satisfactorily. After 24 hours of satisfactory op-
eration, shut down the unit and check all foundation bolts,
shaft bearings, drive set screws, valve train and terminals.
Tighten where required.
Additional Comments: ____________________________
______________________________________________
______________________________________________
______________________________________________
______________________________________________
______________________________________________
______________________________________________
Start-up
By ___________________________________________
Company Name ________________________________
Date __________________________________________
Email _________________________________________
Telephone _____________________________________
Serial Number: __________________________________