Triton 9661 Operation Manual - Manual (Page 166)

5-120
S
ECTION
5 - M
ANAGEMENT
F
UNCTIONS
T
RITON
S
YSTEMS
, I
NC
.
M
ULTI
-C
ASSETTE
C
ASH
D
ISPENSER
O
PERATION
M
ANUAL
M
ODELS
9640/9641/9660/9661
F
UNCTION
: RESET/TEST MODEM
F
ACTORY
D
EFAULT
: N/A
A
CCESS
I
NSTRUCTIONS
:
1.) Select TERMINAL CONFIGURATION from the
MANAGEMENT FUNCTIONS menu.
2.) Select SET TERMINAL PARAMETERS.
3.) Select TELEPHONE.
4.) Select the MODEM SETUP option.
5.) Select RESET/TEST MODEM.
D
ESCRIPTION
:
This function is used to reset and test the internal modem. It should be run after setting any of the
modem configuration parameters to make sure an error was not made. It MUST be run after
changing the DIAL MODE or DIAL RATE, otherwise these new values will not take effect until
the unit is turned off and back on again.
At the conclusion of the test a screen will appear indicating that the MODEM CONFIGURED
AND TESTED OK.
E
RROR
C
ONDITIONS
:
An error message will indicate a problem if the setup string is invalid or the modem is not responding.