Triton 9661 Operation Manual - Manual (Page 246)

D-4
T
RITON
S
YSTEMS
, I
NC
.
A
PPENDIX
D - C
ASH
D
ISPENSER
I
NSTALLATION
I
NSTRUCTIONS
M
ULTI
-C
ASSETTE
C
ASH
D
ISPENSER
O
PERATION
M
ANUAL
M
ODELS
9640/9641/9660/9661
I
NSTALLING THE
D
ISPENSING
M
ECHANISM
Once the Cash Dispenser is securely in place the dispensing mechanism itself can be installed.
Perform the following steps:
**CAUTION**
Be certain that you have not applied power to the
Cash Dispenser before you continue!
1.) Verify the power switch located inside the top of the cabinet is in the OFF (“0”) posi-
tion. Remove the packing material from the ends of the cables that are inside the cabi
net.
2.) Unpack and remove the dispenser mechanism from its shipping container. CAUTION:
Use only the green handle and drive motor in rear of dispenser to lift the mecha-
nism. After the handles are installed, use them to lift the mechanism!
3a.) Align the mounting holes in the handle and internal slide member to the three threaded
holes in the side of the mechanism. Be sure that the notch in the slide member is toward
the rear of the mechanism, as shown in Figure 1.
3b.) Insert three of the provided screws through the slide member and handle and into the
mechanism and tighten.
4.) Repeat steps 3a and 3b for the other side of the dispenser.
5.) Pull the slides out to their fully extended position, as shown in Figure 2.
Figure 1.
Handle
Notch in slide at
rear of mechanism
Screws