Triton 9661 Operation Manual - Manual (Page 245)

D-3
T RITON S YSTEMS , I NC .
M
ULTI
-C
ASSETTE
C
ASH
D
ISPENSER
O
PERATION
M
ANUAL
A
PPENDIX
D - C
ASH
D
ISPENSER
I
NSTALLATION
I
NSTRUCTIONS
M
ODELS
9640/9641/9660/9661
*NOTE*
The unit was shipped with the combination lock unlocked. If it has
become locked, a manual lock can be unlocked by turning the dial at
least four complete revolutions counterclockwise (to the left) stop-
ping on 50 at the main (opening) index. Then run the dial counter-
clockwise to retract the bolt. (Enter 123456 if the cabinet has an
electronic lock.) Turn the dial clockwise (to the right) until it stops
(approximately 90 degrees) to unlock the door and rotate the “T”
handle to open the door
S
ECURING THE
C
ASH
D
ISPENSER TO THE
F
LOOR
Once the Cash Dispenser has been removed from its packaging, and the accessories and keys
have been located and set aside, perform the following steps to secure the Cash Dispenser to the
floor in the selected operating location:
1.) “Walk” the Cash Dispenser to the location where it will be installed. Locate the four
anchor bolt holes in the bottom the cabinet. Mark the location of the four holes on the
floor as guides for the holes that will be used for the anchor bolts (supplied by the in
staller) that secure the cabinet.
2.) Move the Cash Dispenser away from the installation location. Use a 1/2 inch drill bit to
drill four holes at least 2 inches deep into the floor.
3.) Return the Cash Dispenser to the installation location and align the base over the four
holes. Place the four anchor bolts through the cabinet base into the holes in the floor.
Sleeve anchors (1/2 inch by 4 1/4 inches) are recommended to attach the unit to the floor.
Tap the four anchor bolts into the to concrete.
4.) Use a carpenters level to make sure that the cabinet is level front to back and side to side.
The four leveling bolts in the bottom of the cabinet can be adjusted with an adjustable
wrench.
5.) Attach the four nuts to the anchor bolts and tighten firmly.