Triton 9661 Operation Manual - Manual (Page 44)

4-8
S
ECTION
4 - H
ANDLING
C
ASSETTES
M
ULTI
-C
ASSETTE
C
ASH
D
ISPENSER
O
PERATION
M
ANUAL
T RITON S YSTEMS , I NC .
M
ODELS
9640/9641/9660/9661
1. Level the note pile. Compress the note
pile slightly by hand. Single notes must
not protrude from the bundle.
2. Move the pusher plate against the notes
with just enough pressure to hold the
notes in the correct position when clos-
ing the lid and inserting the cassette into
the mechanism.
3. Close the cassette lid. Fold the lid down
to its locked position. The release but-
ton should “pop” out, allowing the lid to
mate cleanly with the body of the cas-
sette. You may need to “tap” the lid
firmly along the front edge to achieve
this. Turn the key counter-clockwise to
lock the cassette.
I
NSTALLING
N
OTE
C
ASSETTES
Using the reverse of the steps used to remove the Note Cassette from the mechanism, slide the
Note Cassette into its slot in the mechanism. Keep the cassette level as you load it, and make sure
the cassette is fully inserted. Once all cassettes have been filled and replaced, they are ready to be
LOCKED into position using the Cassette Lock/Unlock function (see Section 5, Management Func-
tions, for the appropriate procedure). IMPORTANT: Ensure the MULTIPLE AMOUNT pa-
rameter matches the denomination of currency in each Note Cassette! See the procedure for
using the VALUE function to set this parameter, in Section 5, Management Functions.
Figure 4-14. Leveling Note Pile.
Figure 4-15. Moving Pusher Plate Against Notes.
Figure 4-16. Closing Lid.