Triton 9661 Operation Manual - Manual (Page 232)

A-2
T
RITON
S
YSTEMS
, I
NC
.
A
PPENDIX
A - M
ECHANICAL
C
OMBINATION
L
OCK
I
NSTRUCTIONS
M
ULTI
-C
ASSETTE
C
ASH
D
ISPENSER
O
PERATION
M
ANUAL
M ODELS 9640/9641/9660/9661
A
BOUT THE
D
IAL
There are two marks on the dial ring (see drawing). The index at the top is used for opening the lock, The index
30 degrees to the left is used only when changing the combination.
The dial should always be turned slowly and evenly. A revolution is counted each time the selected number is
aligned with the opening index. DO NOT TURN THE DIAL BACK TO COMPENSATE FOR OVER DIAL-
ING A NUMBER. If, when dialing the combination, any number is turned beyond the index, the entire sequence
must be repeated.
Locks are shipped on a factory setting of ‘50’. To unlock, turn the dial to the left (counterclockwise) FOUR turns
stopping on ‘50’.
Then, turn the dial to the right until the bolt is retracted.
U
NLOCKING
3-N
UMBER
C
OMBINATIONS
(F
OR EXAMPLE
, “50-25-50”)
1. Turn the dial to the LEFT, stopping when ‘50’ is aligned with the opening index, the FOURTH time.
2. Turn the dial to the RIGHT, stopping when ‘25’ is aligned with the opening index, the THIRD time.
3. Turn the dial to the LEFT, stopping when ‘50’ is aligned with the opening index, the SECOND time.
4. Turn the dial slowly to the RIGHT until the bolt retracts.
T
O
L
OCK
Turn the dial to the LEFT at least four full revolutions.
CHANGING
INDEX
OPENING
INDEX