In-Situ RuggedReader Operators Manual for Blue RuggedReader - Manual (Page 23)

23
0055450 rev. 002 10/07 Rugged Reader Operator’s Manual
1. Save your open files and close any running
programs.
2. Press until the power button menu
appears.
3. Tap Power Off.
The keypad backlight stays on for a few
seconds after the device shuts off. Until the keypad backlight turns off,
the device cannot be powered on again.
To power on your RuggedReader, hold down until the green
notification light appears. Introductory splash screens will be displayed,
then the Today screen. This process takes about a minute.
Resetting the Device (Soft Reset)
Some programs require you to reset your device during installation. Follow
the steps below to reset the RuggedReader:
1. Save open files and close any running
programs.
2. Press until the power button menu
appears.
3. Choose Reset.
If your device is locked up, you can reset it without the power button
menu. Just press the power button for 10 seconds or until the screen goes
dark. After a few seconds, the device turns on again.
SECTION 3: USING THE HARDWARE