In-Situ RuggedReader Operators Manual for Blue RuggedReader - Manual (Page 29)

29
0055450 rev. 002 10/07 Rugged Reader Operator’s Manual
THE TOUCHSCREEN
Protecting the Touchscreen
The touchscreen is sealed to protect your device against water and dust.
Protect your touchscreen from impact, pressure, or abrasive substances
that could damage it. To further protect the touchscreen, apply one of the
adhesive screen protectors that came with your RuggedReader. We
recommend that you apply a new screen protector every 30 days. Extra
screen protectors are available from In-Situ Inc. (catalog no. 55470).
To apply a screen protector, follow these steps:
1. Make sure the RuggedReader screen is free of oils and dirt. You can
wipe it with a microfiber cloth.
2. Peel back the paper liner from the screen protector,
exposing approximately one inch.
3. Align bottom corners of the screen
protector with the RuggedReader screen,
sticky side down.
4. Smooth the screen protector while peeling back the liner, working out
air bubbles as you go. Continue smoothing until the paper liner is
removed.
SECTION 3: USING THE HARDWARE
TIP: Some air
bubbles may still
be visible, but
they fade away in a short
time. You can use a credit
card to gently push out any
excess air.