In-Situ RuggedReader Operators Manual for Blue RuggedReader - Manual (Page 24)

24
0055450 rev. 002 10/07 Rugged Reader Operator’s Manual
Restoring Factory Defaults (Hard Reset)
Follow the steps below to restore the hard drive, settings, and icons to
their original factory state on your device. WARNING! Restoring the device
to its original factory state will permanently erase data saved on the
device, any software you installed, and any changes you made to the
device, including settings changes.
To restore the device to its original factory state, follow these steps:
1. Reset the device from the power button menu or by holding down the
power button until the display goes dark.
2. When the green LED light appears on the front of the RuggedReader,
simultaneously press and hold the following buttons for several
seconds: the Home button, the up arrow on the Four-way directional
button, and the Context menu button.
3. Hold the buttons until the RuggedReader splash screen appears and
then disappears. Factory settings are restored automatically.
SECTION 3: USING THE HARDWARE
WARNING:
Restoring the
device to its
original factory state will
permanently erase data
saved on the device,
software installed by In-Situ
Inc. (Win-Situ Mobile,
Pocket-Situ 4, TDG
Logger), any software you
installed, and any changes
you made to the device,
including settings changes.
Green LED