In-Situ RuggedReader Operators Manual for Blue RuggedReader - Manual (Page 31)

31
0055450 rev. 002 10/07 Rugged Reader Operator’s Manual
LED SIGNALS
The RuggedReader signals events and processes using LEDs.
Charge LED (Red)
This red light appears to the left of the Start menu button on the keypad.
Flashing : battery is currently charging
Solid
: wall charger is connected but battery is fully charged
When the device is suspended or powered off, the charge LED does not
appear.
Notification LED (Green)
The green LED is located to the right of the Enter button on the keypad. It
appears briefly when you power on the unit after the device is reset or
restored to factory defaults.
USING PERIPHERAL DEVICES
The RuggedReader accepts several peripheral devices.
• The USB Host (mini A) accepts devices like USB flash drives and
keyboards.
• The Compact Flash (CF) and Secure Digital (SD) card slots accept
memory cards and SDIO cards, such as GPS, modem, and
Bluetooth cards.
USB Devices
To install a USB device, plug the mini end of a USB
communications cable into the USB Host (labeled A on
your device). You may need to use a USB mini-to-full
size adapter.
SECTION 3: USING THE HARDWARE
USB Host (mini A)
TIP: To be
compatible with
Windows Mobile
5.0, some USB serial
devices require drivers.
Refer to your USB device’s
manual or contact the
manufacturer to determine
compatibility.