In-Situ RuggedReader Operators Manual for Blue RuggedReader - Manual (Page 63)

63
0055450 rev. 002 10/07 Rugged Reader Operator’s Manual
REPLACING THE BATTERY PACK
To replace the battery pack, follow these steps:
1. Close all running programs.
2. Suspend the device (press the power button briefly and release).
3. Slowly unhook and lift up the bottom hand strap latch.
CAUTION: Do not let the hand strap hook hit the display.
4. Press on the battery door about ¼" beneath the
door latch and slide the door latch to the right.
5. Remove the battery door.
The door may make a noise while it is being removed,
caused by the door scraping against the battery. The
sound is normal and no damage is done when you hear
this sound.
6. Remove the old battery pack.
7. Make sure the battery contacts of the replacement battery pack are
clean and dry.
SECTION 7: CARE AND MAINTENANCE
CAUTION: The
device only
stays on for
about five seconds without a
power source. Always
suspend your device
before replacing the
battery pack.
➔
➔
Press
here
➔
➔