NORD Drivesystems BU0280 - Manual (Page 37)

4 Commissioning
BU 0280 GB Subject to technical amendments 37
4.2.2 Interpretation of data in the Assembly Object
In the EDS file it is assumed that there is only one FI, or that all FIs have the same setting. This must also be
represented by the ODVA. The following official table results from this. Otherwise, all possible or meaningful
combinations must be recorded.
Instance Profile Length Significance Parameterisation
( P160 )
20 AC-Drive 4 STW + SW1 (only one FI) 1
70 AC-Drive 4 ZSW + IW1 (only one FI)
21 AC-Drive 4 STW + SW1 (only one FI) 2
71 AC-Drive 4 ZSW + IW1 (only one FI)
100 NORDAC 5 Bus module outputs + STW + SW1 (only
one FI) 3
110 NORD-AC 5 Bus module inputs + ZSW + IW1 (only one
FI)
101 NORD-AC 8 STW + SW1 + SW2 + SW3
(only one FI)
4
111 NORD-AC 8 ZSW + IW1 + IW2 + IW3
(only one FI)
102 NORD-AC 33 Bus module outputs + four FIs
Structure for each FI:
STW + SW1 + SW2 + SW3 5
112 NORD-AC 33 Bus module inputs + four FIs
Structure for each FI:
ZSW + IW1 + IW2 + IW3
120 NORD-AC 1 to 33 Control values
All combinations possible, parameterisation via
P161 to P165
0
130 NORDAC 1 to 33 Status values
All combinations possible, parameterisation via
P161 to P165
Explanation of abbreviations:
STW
= FI control word
SW1 – 3 = FI setpoints 1 to 3
ZSW
= FI status word
IW1 – 3 = FI actual value 1 to 3